Chapter 5 — Operating the Library Monitoring Your Library
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
166
3. Select the media type, if necessary, and the unit of measure for the
density values.
4. Click Go. The Storage Density screen showing the selected metrics
displays.
View Robot Utilization Information
The Robot Utilization by Hour metric lets you monitor the percentage of
each hour that the library’s robotics are actively operating over the last 24
hours. The data is updated every hour while the library is powered on.
The Robot Utilization by Hour metric can include up to 24 data points,
one for each hour that data was collected over a 24-hour period. The
first time period begins one full hour after the library is powered on.
Data collected during the first partial hour following power-on is
discarded as invalid data.
The data is stored in volatile memory and is not retained when the
library is powered off.
Use the following steps to view the robot utilization information.
1. Select General > General Status from the toolbar menu. The General
Status screen displays.
2. Click Robotics to display the Robotics Status screen.
Figure 91 The Storage Density metrics screen.
To Next Page
Loading...
