Chapter 4 — Configuring the Library Configuring the Global System Settings
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
117
5. Click Save. The screen refreshes to show the new or updated mail
recipient in the Recipients portion of the Mail Recipient screen
(Figure 54 on page 116).
6. If desired, select Send Test next to the newly added mail recipient to
send a test email.
7. Repeat Step 2 on page 116 through Step 6 on this page to configure or
modify additional email recipients.
8. Click Previous to return to the System Setup screen.
Enable Email for the Auto Configuration Save File
Overview Having a current backup of the library‘s metadata (the library
partition configuration, the MLM and DLM databases, and any BlueScale
encryption keys) is an essential component of any disaster recovery plan.
For more information about protecting the library metadata, see Back Up
and Protect the Library Metadata on page 511.
In the event that you need to restore the library configuration, you can use
either the automatically saved configuration backup file from the LCM or
the emailed copy (see Restore From an Auto Configuration Save File on
page 377).
Receive Select the type(s) of messages that the user receives by selecting one or more of
the message types listed.
Fatal
— An error occurred that prevents the library from continuing operation.
Immediate attention is required.
Error
— An error occurred that impacts the operation of the library. Determine
the cause of the error and remedy it as soon as possible.
Warning
— The library detected conditions that may impact operation.
Determine the cause of the problem and remedy it as soon as possible.
Informational
— Activities that generate system messages have occurred.
Notes:
Selecting a message type automatically sends all messages of that type to the
recipient as they are generated by the library.
If no message type is selected, the library does not automatically send
messages to the recipient. However, messages can still be sent to the recipient
on an individual basis when traces or diagnostics are run.
Do not select message types for the autosupport@spectralogic.com mail
recipient. This mail recipient is only used to receive AutoSupport ticket
requests or ASL and HHM files that are generated by the library.
For this field... Do the following...
To Next Page
