Chapter 12 — Library Troubleshooting Accessing the Library Interior and Troubleshooting Blockages
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
387
6. Access the interior of the library.
If the library is installed in a rack that provides access to the library’s
side panels, you can remove the side access panels, as described in
Access the Interior from the Side.
Note: The T680 rack provides access to the library side panels.
If the library is installed in a rack that does not allow access to the
library’s side panels, you must access the interior through the front
of the library. After preparing the library for access, see Access the
Interior from the Front for instructions.
Access the Interior from the Side
To access the interior of the library from the side, use the following steps in
the following sections.
Remove the Side Access Panel
Note: The drives and chambers are most easily accessed from the right
side of the chassis (as viewed from the front).
1. While holding the panel against the chassis, use a #2 Phillips
screwdriver to remove the screws securing the lower access panel to the
right side of the library.
Lift the bottom access panel off the chassis and set it aside.
Figure 236 Removing the right side access panels.
To Next Page
Loading...
