Spectra T200 - Exchange Magazines or Cartridges in a Partition

Chapter 7 — Importing and Exporting Cartridges Exporting or Exchanging Magazines and Cartridges
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
235
Exchange Magazines or Cartridges in a Partition
The process for exchanging a magazine or cartridges in a partition is the
same as that for exporting a magazine up to the point where the magazine
is delivered to the TAP.
Note: If you want to exchange only the expired cleaning cartridges in a
cleaning partition, skip to Export or Exchange Expired Cleaning
Cartridges on page 236.
1. Complete Step 1 on page 233 through Step 4 on page 234 to begin the
exchange process.
2. When you click Export/Exchange, the library retrieves a magazine from
the selected location and places it in the TAP. The TAP door opens and a
Feedback Required screen displays.
a. Remove the magazine from the TAP and either:
 Place another magazine of the same type in the TAP.
—OR—
 Remove or exchange one or more cartridges in the magazine and
then place the magazine back in the TAP.
Note: If you are exchanging cartridges, make sure to only
exchange cartridges of the same type.
The alignment guides on each side of the magazine (see Figure 134
on page 221) slide easily into the grooves on either side of the TAP
opening. If the magazine does not slide into place easily, remove
and reinsert it.
b. Gently raise the TAP door and press it firmly into the latch for
approximately one second.
Note: Close the TAP door firmly, but do not use excessive force.