Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
372
15. If desired, edit the IP address for the BlueScale Vision camera icon on
the BlueScale user interface status bar.
a. From the library’s user interface, select Configuration > System. The
System Setup screen displays.
b. Scroll down until you see the Other Settings pane (see Figure 48 on
page 100).
c. Enter the camera’s updated IP address in the BlueScale Vision IP
Address field.
d. Click Save. The presence of a camera icon on the status bar indicates
that the IP address is configured.
Resetting the White Camera to DHCP
Notes: The library must be powered on while you perform the reset.
The camera’s reset button is toward the left when viewed
from the front of the library. If possible, access the interior of
the library by removing the left side panel.
Use the following steps to access the camera and reset it to DHCP
addressing:
1. Remove the left side panel as described in Access the Interior from the
Side on page 387.
Note: If you cannot access the side panels, you may be able to reach
through the opening above the LCD mounting panel after you
access the library interior from the front (see Access the Interior
from the Front on page 389). If neither option is available,
contact Spectra Logic Technical Support for assistance (see
Contacting Spectra Logic on page 7).
To Next Page
Loading...
