Chapter 5 — Operating the Library Using a USB Device
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
176
Connect a USB Device to the Library
Notes: Not all USB devices are compatible with the library. If you
are unable to access a USB device from the library, remove it
and use a different one. If the LCM stops responding after
you insert an incompatible USB device, reboot the LCM as
described in Reset the LCM on page 359.
The library only recognizes FAT-formatted, not NTFS-
formatted, USB devices.
Plug the USB device into the LCM before beginning a
procedure that reads or writes data to allow time for device
recognition. For many utilities, the option to read from or
write data to a USB device is not available if a USB device
was not connected to the LCM before you select the utility.
Use the following steps to connect a USB device to the library.
1. Locate the USB port you want to use.
2. Plug the USB device into the USB port and allow time for the device to
mount before continuing.
Figure 102 Location of the USB port on the Spectra PC.
Figure 103 Location of the USB ports on the Spectra LS.
To Next Page
Loading...
