Spectra T200 - Configure the Bluescale Vision Camera - Black

Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
368
14. When you finish configuring the camera, click Exit to close the wizard.
15. If desired, edit the IP address for the BlueScale Vision camera icon on
the BlueScale user interface status bar.
a. From the library’s user interface, select Configuration > System. The
System Setup screen displays.
b. Scroll down until you see the Other Settings pane (see Figure 48 on
page 100).
c. Enter the camera’s updated IP address in the BlueScale Vision IP
Address field.
d. Click Save. The presence of a camera icon on the status bar indicates
that the IP address is configured.
Configure the BlueScale Vision Camera - Black
1. Download the camera software from the support portal Downloads >
Tools page or click Vivotek_InstallWizard-v1.1.0.27.exe.
Note: The Vivotek FD8361 Fixed Dome Network Camera User’s Manual
says that the software is located on a CD shipped with the
camera. The CD is not shipped with Spectra Logic libraries.
Download the software using the link above.
2. Open the folder and run IW2_Setup-v1.1.0.27.exe. The program
searches the network for any compatible network cameras.