Spectra T200 - BlueScale Media Lifecycle Management; Spectra Certified MLM-Enabled Media

Chapter 9 — Configuring and Using Media Lifecycle Management BlueScale Media Lifecycle Management
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
267
Automatic Media Discovery
Overview The Media Auto Discovery feature is a background process that
loads MLM-enabled cartridges into a TS11 xx technology drive or an LTO-4 or
later generation drive, records the MLM information to the cartridge MAM,
adds the cartridge to the MLM database, and returns the cartridge to its
original location. The process is performed by the library independently from
the storage management software. Media Auto Discovery must be enabled
on the library, as described in Enabling MLM and Configuring Global
Settings on page 276, before it can be used.
Note: If you do not want to use automatic media discovery, you can
wait until the library loads and then unloads each cartridge from
an MLM-capable drive for the first time during normal
operation. When the cartridge is unloaded from the drive, the
library discovers it and records the MLM data to the cartridge
MAM and enters the data into the MLM database.
When Media Auto Discovery is enabled, MLM provides two options for
proactively discovering media in a partition:
 Media Auto Discovery — The default process that collects information
from the cartridge MAM and adds it to the MLM database. The Media
Auto Discovery process only operates on newly imported cartridges that
are not already in the MLM database.
Note: Media Auto Discovery loads and reads the MAM in the tape, but
does not thread the tape. The drive only reports the maximum
and remaining capacity for the tape after the tape is threaded.
Therefore, these statistics report as "0" until a drive reads from,
or writes to, the tape.
 PreScan—An optional process that replaces Media Auto Discovery. If
the PreScan feature is enabled in a partition, the PreScan process runs
instead of the Media Auto Discovery process and operates on all of the
media in the partition, regardless of whether it is already in the MLM
database or not.
In addition to adding information collected from the cartridge MAM to
the MLM database, PreScan performs a basic functionality test and
health check on each imported cartridge (see Using PreScan on
page 288 for more information).
Discovery Process The discovery process can either be manually initiated
by you or set to run automatically so that the library discovers the
cartridges and adds their information to the MLM database shortly after a
cartridge is imported into the library. The discovery process is independent
of any storage management software.