Appendix C — Specifications Library Specifications
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
531
Size and Weight
The following table shows the size and weight specifications for the library
and other components.
Note: To calculate the approximate weight of a loaded library, add the
weight for each drive, controller, and power supply, plus the
weight of each TeraPack magazine full of cartridges to the
weight of the library itself.
Service Access Requirements
A minimum of 24 inches (61 cm) of clearance is required on the right hand
side of the library to provide service access. In addition, leave a minimum
of 24 inches (61 cm) at the front and back of the library for service and
operator access. Providing 36 inches (91 cm) of clearance on all sides of the
library is highly recommended.
Refer to the Spectra T200, T380, and T680 Libraries Site Preparation Guide for
detailed information about space and access requirements.
Parameter
Specification
a
T200 T380 T680
b
Height 35 in. (89 cm) 49 in. (125 cm) 80.5 in. (204.5 cm)
Width
Chassis
Front panel
17.5 in. (44.4 cm)
19.0 in. (48.3 cm)
17.5 in. (44.4 cm)
19.0 in. (48.3 cm) 24 in. (61 cm)
Depth
(with drive cover)
41 in. (104 cm) 41 in. (104 cm) 48 in. (122 cm)
Weight
Base chassis
Maximum
c
230 lb (104 kg)
428 lb (194 kg)
305 lb (138 kg)
627 lb (284 kg)
765 lb (347 kg)
1211 lb (549 kg)
Each Tape Drive
(with drive sled)
LTO-2 through LTO-4: 11.5 lb (5.2 kg)
LTO-5 and LTO-6: 11.6 lb (5.3 kg)
LTO-7: 11.2 (5.1 kg)
LTO-8: 11.0 (5.0 kg)
TS11xx technology: 17.5 lb (8 kg)
Each TeraPack
magazine
with ten LTO cartridges: 5.1 lb (2.3 kg)
with nine TS11xx technology cartridges: 5.6 lb (2.5 kg)
Each controller 5 lb (2.3 kg)
Each power supply 4 lb (1.8 kg)
a. All dimensions and weights are approximate and are rounded up to the nearest tenth.
b. The T680 is shipped and installed in a rack; the sizes shown are for the library rack.
c. The maximum weight assumes the maximum number of drives and media installed. The maximum weight does not include the
weigh of the rackmounting hardware for the T200 and T380 libraries.