Spectra T200 - Configure a Package Server

Chapter 4 — Configuring the Library Configuring Optional Library Settings
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
137
Configure a Package Server
Overview Configuring a package server is optional. A local package
server can be used to store BlueScale packages downloaded from Spectra
Logic for updating the BlueScale software or library component firmware.
Update packages can also be downloaded directly from the Spectra Logic
website to the memory card in the library’s LCM or to a USB device.
Note: For additional information about BlueScale packages and how to
use them, see Updating the BlueScale Software and Library
Firmware on page 441.
User Privilege Requirements Only a user with superuser or administrator
privileges can configure a package server.
Configure a Package Server Use the following steps to configure, modify,
or delete a local package server.
1. Identify the server or servers you want to use for storing BlueScale
packages. Make sure that these servers can access the Internet and that
they are on the same network as the libraries you want to update.
Note: Both Microsoft’s Internet Information Services (IIS) and the
Unix-based Apache server work as package servers.
2. Log into the library as a user with superuser or administrator privileges.
3. Select Maintenance > Package Update. The Package Update screen
displays.
Figure 65 The Package Update screen.