Spectra T200 - Access the Interior from the Front

Chapter 12 — Library Troubleshooting Accessing the Library Interior and Troubleshooting Blockages
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
389
Access the Interior from the Front
If you cannot access the sides of the library while it is installed the rack, use
the steps in the following sections to remove the front panel, fan assembly,
and chamber shelves.
Remove the Front Panel
1. From the front of the library, pull firmly outward on the top edge of the
filter cover panel to release the magnetic latches and tip the cover out
from the front pane.
2. Lift the cover upward to disengage the tabs on each side of the cover
from the slots in the front of the library.
3. Remove the cover and set it aside.
Important
Do not remove the library from the rack.
Figure 237 Remove the fan cover panel.
Pull outward
Tab
Lift upward