Appendix C — Specifications Tape Drive and Media Specifications
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
541
NDMP Support
Spectra Logic tape libraries are compatible with local, remote, and three-way
NDMP (Network Data Management Protocol) topologies, where the tape
library is connected to the NDMP data mover host over Fibre Channel.
TAPE DRIVE AND MEDIA SPECIFICATIONS
This section provides the basic specifications for the tape drives and media
supported by the library.
Notes: SCSI drives have been discontinued and are no longer
available for purchase. If your library includes these drives,
refer to the documentation that accompanied your library
when you received it for specification information.
The specifications in this section are provided for
convenience only. Refer to the tape drive documentation for
the most current specifications (see LTO Ultrium Tape Drives
on page 20 and TS11xx Technology Drives on page 20).
The specifications in this section are subject to change
without notice.
For T10K Drive specifications, see Using StorageTek T10K
Drives in a Spectra TFinity Library.
LTO Tape Drive Specifications
This section provides specifications for the LTO drives supported by the
library. See Tape Media Specifications on page 548 for information about
the media used in the library.
Note: LTO drives and media are also referred to as Ultrium or LTO
Ultrium drives and media.
To Next Page
Loading...
