Chapter 4 — Configuring the Library Enabling BlueScale Software Support, Options, and Upgrades
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
104
4. Click Save. The System Setup screen refreshes and displays the new
activation key and its description in the list of keys. The option is
available for immediate use.
Note: Keep a record of all activation keys listed on the Option
Enablement pane of the System Setup screen. You need to re-
enter them if the library is reset to factory defaults.
Add Options
This section describes how to determine the Hardware ID and obtain
activation keys for new options after the initial installation. See Renewing
the BlueScale Software Support Key on page 438 if you need to renew or
extend your service contract, which includes the BlueScale Software
Support key.
Determine the Library Serial Number
The library serial number (Hardware ID) is required for renewing or
extending your service contract, which includes the BlueScale Software
Support key, and for purchasing additional Capacity on Demand (CoD) or
other upgrade options.
Use the following steps to determine your library’s serial number.
1. Access the System Setup screen (see Accessing the System Setup Screen
on page 99).
2. Make a note of the library’s serial number (Hardware ID), which is
needed to generate the activation keys.
The BlueScale Software Support key and all option activation keys are tied to the
library serial number. If you have multiple libraries, you need separate activation
keys for each library.
Figure 50 Locate the library’s serial number (Hardware ID).
The library’s hardware ID
To Next Page
Loading...
