Chapter 4 — Configuring the Library Configuring Optional Library Settings
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
139
5. Click the correct button to add, delete, or edit a package server.
Task Procedure
Add a package
server
1. Click
Add. The Configure Package Server screen displays.
2. Fill in the requested information:
Required
— Name and IP Address. If no Proxy is set, the IP Address can be an
IPv4 or an IPv6 address. If a Proxy is set, the IP Address must use IPv4.
Optional
— Port, Proxy, and Directory fields use default values if nothing is
entered. The Proxy, if set, must use IPv4.
3. Select or clear Automatically Download Latest Package.
If selected, the library checks the package server once a week for a library
update package and drive firmware package newer than what the library is
currently running. If a new package is available, the library downloads it,
generates a system message, and displays an icon on the status bar to indicate
the update availability.
If cleared, you must check for updates manually.
4. Click Save. The screen refreshes and adds the new server to the list of available
package servers.
Note: If you specify the directory, make sure you include the full path to the
directory where the BlueScale packages are stored.
Edit a package
server
1. Click Edit next to the server’s name and details. The Configure Package Server
screen displays, with the appropriate fields completed.
2. Edit the server information as necessary.
3. Click Save.
Delete a
package
server
Click Delete next to the server’s name and details.
Important: There is no confirmation requested when you delete a package
server. After you click Delete, the server is immediately removed from the list of
available package servers. However, the packages on the server are not deleted.
Figure 67 The Configure Package Server screen.
To Next Page
Loading...
