Chapter 4 — Configuring the Library Setting the Camera IP Address
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
152
4. Select Network. The network connections configuration screen displays.
5. Select either Obtain an IP address automatically (DHCP) or Use the
following IP address.
If you select Use the following IP address, enter the desired IPv4
address, subnet mask, and default gateway addresses as required for
your network and click Save. The factory defaults are:
6. After saving the new camera configuration verify the settings by
attempting to access the camera at the new IP address (see Using a Web
Browser on page 172).
Figure 79 Configure the camera IP addressing on the
network configuration screen.
IP Address Subnet Mask Default Gateway
10.10.10.11 255.255.255.0 10.10.10.1
If you set the camera to use a fixed IP address, make sure that you record that
address so that it can be found later. If you do not know the camera’s IP address, you
must reset the camera to use DHCP addressing before you can connect to it. The
reset process requires physically accessing the camera (see Discovering and Setting
the BlueScale Vision Camera IP Address on page 362).
To Next Page
Loading...
