Spectra T200 - Page 206

Chapter 6 — Configuring and Managing Partitions Creating a Storage Partition
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
207
3. If necessary, configure any additional ports.
If the exporting
controller is a...
And... Then...
RIM  You only selected one port on the Robotic
Path Visibility screen,
—OR—
 You already configured both Fibre
Channel ports,
Proceed to Confirming and Saving
the Partition Settings on page 208.
RIM You selected both ports on the Robotics
Visibility screen,
1. Repeat the configuration steps in
this section to configure the other
Fibre Channel port.
2. After you finish configuring the
second port, proceed to
Confirming and Saving the
Partition Settings on page 208.
F-QIP  All of the drives in the partition are
connected to the exporting F-QIP,
—AND—
You only selected one port on the Robotic
Path Visibility screen,
—AND—
You selected the same port on the Drive
Visibility screen,
—OR—
 You already configured all Fibre Channel
ports,
Proceed to Confirming and Saving
the Partition Settings on page 208.
F-QIP  All of the drives in the partition are
connected to the exporting F-QIP,
—AND—
You selected both ports on the Robotic
Path Visibility screen and the Drive
Visibility screen,
—OR—
 You selected different ports on the
Robotics Visibility and Drive Visibility
screens,
1. Repeat the configuration steps in
this section to configure the other
Fibre Channel port on the
exporting controller.
2. After you finish configuring the
second port, proceed to
Confirming and Saving the
Partition Settings on page 208.
F-QIP Some or all of the drives in the partition are
not connected to the exporting F-QIP,
1. Repeat the configuration steps in
this section to configure the ports
on the F-QIP(s) used to provide
connectivity for the drives.
2. After you finish configuring the
remaining ports, proceed to
Confirming and Saving the
Partition Settings on page 208.