Spectra T200 - Page 248

Chapter 8 — Using the Cartridge Inventory Viewing and Downloading the Cartridge Inventory
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
249
4. Use the Source drop-down list to select the location for which you want
to view the cartridge inventory, then click Go. The Source list refreshes to
display a list of the cartridges in the requested location type.
Notes:  The available sources depend on the type of partition selected.
 If the selected source does not contain any cartridges, the
source list shows “No sources found.”
 The From TAP option is only available when you access the user
interface from the front panel.
Figure 146 Select the source type for which you want to view the inventory.
Available sources
(storage partition
shown)
Partition Type Available Sources
Storage  Storage
— Lists the barcodes of the cartridges currently in the selected
partition’s storage pool.
 Entry/Exit
— Lists the barcodes of the cartridges currently in the partition’s
entry/exit pool.
 Drives—Lists the barcode of the cartridge currently in each drive assigned to
the partition. Only drives that contain a cartridge are included in the list.
 From TAP
— Configures a move that transfers the magazine containing the
destination slot to the TAP so that you can insert a cartridge (see Moving
Cartridges Within a Partition on page 254).
 All—Lists all of the cartridges in the partition, regardless of location.
Cleaning  Cleaning—Lists the cleaning cartridges currently in the selected cleaning
partition.
 From TAP
— Configures a move that transfers the magazine containing the
destination slot to the TAP so that you can insert a cartridge (see Moving
Cartridges Within a Partition on page 254).
 All—Lists all of the cartridges in the partition, regardless of location.
Note: If an “x” appears next to the slot number in the source list for a cleaning
partition, the cleaning cartridge is expired.