Spectra T200 - Page 382

Chapter 12 — Library Troubleshooting Restoring the Library Configuration
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
383
6. Scroll through the list of advanced utilities and select one of the
following, as applicable for your situation. The screen refreshes to show
the details for the selected restore utility.
Note: The Advanced Utilities screen lists the utilities in alphabetical
order. The following table lists the utilities in most-frequently-
used order.
7. Click Run Utility.
After a brief delay, the Utility Results screen appears, showing that the
configuration file was uploaded and/or the configuration restored. The
library then performs a power- cycle reset.
Use this Restore
Option...
To...
Restore Library
Configuration from
Auto Save
Restore using an automatically generated configuration backup file that is
stored on a USB device or LCM memory card (see Restore From an Auto
Configuration Save File on page 377).
Note: The automatically generated configuration backup file contains the
library configuration, as well as the MLM and DLM databases.
Restore Library
Configuration from
USB
Restore a library configuration file previously stored on a USB device.
Note: Before starting this procedure, insert the USB device into the USB port
on the LCM and allow time for the device to mount.
Upload Backup
Configuration
Upload a configuration backup file to a temporary location in the library from a
computer that has network access to the library.
Note: Upload Backup Configuration is only available when you access the
library through the BlueScale web interface.
1. Click Upload Backup Configuration at the top of the screen.
2. When the upload is complete, you must then run the Restore Library
Configuration from Uploaded File utility to restore the library configuration.
Restore Library
Configuration from
Uploaded File
Complete the restore process after using Upload Backup Configuration to upload
a saved configuration file from a computer.
Note: This option is used in conjunction with Upload Backup Configuration,
which must be run first.
Important
Before the library is restored using a saved configuration file on the USB device, the
current configuration is saved to the USB device with a time stamp indicating when
the file was created. The library is then restored using the selected auto saved
configuration. The USB device now contains one additional configuration file.