Spectra T200 - Page 422

Chapter 13 — Drive Troubleshooting Troubleshooting Drives
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
423
SCD Codes for LTO-2 Drives If multiple errors occur, the code with highest
priority (lowest number) displays first. Once corrected, the code with the
next highest priority displays, until none remain.
Note: The SCD is blank during normal operation.
J Incompatible Media.
The drive determined that incompatible media has been loaded into the drive.
P The cartridge in the drive is write-protected. The storage management software
cannot write data to a write-protected cartridge. The library cannot update the
cartridge MAM when the cartridge is write-protected.
u Firmware update is in progress.
b, c, H, h,
n, o
N/A Reserved or not actively in use, or no error or message assigned.
There may be a problem with the SCD. Reset the drive and determine whether
all segments on the SCD are lit.
 If they are all lit, confirm that the drive is using the current firmware version
(see Updating Drive Firmware on page 473) and update the firmware if
necessary.
 If the problem persists, contact Spectra Logic Technical Support (see
Contacting Spectra Logic on page 7).
…N/AThe message display has lost communication with the drive. This message
appears on Line 2 of the message display. The three dots may occasionally
display during normal processing.
Code DLM
Health
Icon
Cause and Solution
Code
DLM
Health
Icon
Cause and Solution
0 No error occurred. No action is required.
The power was cycled or diagnostics finished with no errors.
1 Cooling problem.
The recommended operating temperature was exceeded. Perform one or more
of the following:
 Ensure that the cooling fan is rotating and is quiet.
 Remove any blockage that prevents air from flowing freely through the tape
drive.
 Ensure that the operating temperature and airflow is within the specified
range.
 If the operating temperature is within the specified range and the problem
persists, replace the drive.
Note: The error code clears when you reset or power cycle the tape drive or
when you place it in maintenance mode.