Spectra T200 - Page 443

Chapter 14 — Maintaining the Library Updating the BlueScale Software and Library Firmware
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
444
6. If you want to save the output from the utility, use the check boxes at
the top of the screen to select the location; otherwise skip to Step 7.
7. Click Run Utility. The Utility Results screen displays, showing a list of
the firmware levels for all installed components.
8. If requested to do so, send this information to Spectra Logic Technical
Support (see Contacting Spectra Logic on page 7) for advanced
troubleshooting.
Selecting this
location...
Saves the output...
Mail results to As an attachment to an email sent to the specified mail recipient. Use the drop-
down list to select the recipient for the report file.
To send the email with the output to someone who is not already listed as a
library user, you must first configure that person as an email recipient (see
Configure Mail Users on page 115).
Note: Do not use the default autosupport@spectralogic.com email recipient
unless Spectra Logic Technical Support specifically instructs you to do so.
Spectra Logic does not save emailed results files unless they are specifically
requested for troubleshooting.
Save to USB To a USB device connected to a USB port on the LCM.
Note: This option is only available if you inserted a USB device in Step 3 on
page 443.
Figure 272 The results screen for the Display Firmware
Versions utility.