Spectra T200 - Install the Update Package

Chapter 14 — Maintaining the Library Updating the BlueScale Software and Library Firmware
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
449
6. The Select Library Package screen displays, listing the file names for the
available BlueScale packages.
Note: The file names begin with the BlueScale version number,
followed by the date of release in YYYYMMDD format.
7. Select the appropriate BlueScale package.
Notes:  If the Package does NOT display in the USB or Package
server section, you may have downloaded the package for
the wrong library type or the wrong signed/unsigned
package type.
 BlueScale packages may be found on the sources described in
the table below.
Figure 276 Select the BlueScale package.
Source Description
Spectra Logic Select and download the desired BlueScale package from Spectra Logic’s package
server to the memory card in the LCM and then install it.
Notes:
 The library must have a connection to the Internet before you can use this option
(see Configure Network Settings on page 112).
 If directed to do so by Spectra Logic Technical Support, update the IP address and
package directory for the Spectra Logic package server (see Configure a Package
Server on page 137).
Memory Card Select the desired BlueScale package from packages already stored on the memory
card in the LCM.
USB Device Select the desired BlueScale package from packages stored on a USB device. There is a
brief delay while the library accesses the USB device when you select this option.
Notes:
 The USB Device option is only available if you connected a USB device containing the
BlueScale package to a USB port on the LCM in Step 2 on page 448.
 The BlueScale package must be stored in the root directory of the USB device.