Spectra T200 - Installing Cord Locks and Chassis Grounding

Chapter 14 — Maintaining the Library Installing Cord Locks and Chassis Grounding
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
462
2. Using a 5/32-inch open-end wrench, remove the KEP nuts and screws
that secure the clamp to the mounting bracket and remove the clamp.
3. Slide the clamp over the AC power cord and reinstall the screws and
KEP nuts to secure the clamp to the cord.
4. Plug the cord back into the AC input connector on the library.
Figure 287 The cord lock assembly
(removed from AC switch plate for
clarity).
Figure 288 Assembled cord
lock with power cord (removed
from AC switch plate for clarity).
Mounting bracket
Screw and KEP nut
Clamp