Appendix C — Specifications Tape Drive and Media Specifications
December 2019 User Guide—Spectra T200, T380, and T680 Libraries
553
Detailed Specifications for LTO Cartridge Barcodes
Figure 319 shows the dimensional specifications for LTO labels with the
alphanumeric characters above the barcode.
Note: When using barcode labels with alphanumeric characters along
the bottom edge, the label must be positioned so that barcode is
at least 13.72 mm below the top edge of the cartridge to ensure
that the barcode reader can read the label.
Figure 319 barcode specifications for half-inch media; alphanumeric characters on top.
Alphanumeric
Barcode start character
11.1 mm,
minimum
17 mm
+0/–0.8
Quiet Zone
characters
79 mm +0/–.8
74.088 mm, nominal
4.32 mm,
Quiet Zone
Quiet Zone
4.32 mm,
minimumminimum
Barcode stop character
To Next Page
Loading...
