Why Stratasys F770 3D Printers say 'Cannot change material type during build'?
The 'Cannot change material type during build' message on Stratasys 3D printers indicates that the printer is currently in the process of building and you are attempting to change model or support material during the build. You cannot change material types while the printer is in the process of building a part. Wait until the build is complete before changing materials.
What to do if Stratasys F770 3D Printers are 'User requested'?
The 'User requested' message on Stratasys 3D printers indicates that a pause was initiated by the operator or inserted within the job’s file. Resume the build by pressing the Play button within the Build page.
Basic safety tips for printer installation, operation, and maintenance.
Explanation of hazard classifications and product safety symbols used in the guide.
Highlights components and areas of the printer as potential safety hazards.
General safety guidelines to follow when working with the printer.
Details on configuring network settings and setting up Insight/FDM Control Center.
Instructions for replacing the printer's model or support heads.
Steps involved in preparing, selecting, and executing a print job.
Procedures for calibrating the printer's tips.
Explanation of how warnings and errors are displayed and interpreted.
Troubleshooting table listing common issues and their resolutions.
General| Print Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Connectivity | Ethernet, USB |
| Software | GrabCAD Print |
| Build Volume | 1000 x 610 x 610 mm |
| Material Compatibility | ASA |
| Print Speed | Not found |
| Power Requirements | 230 VAC, 50/60 Hz |
To Next Page
