188 TimeHub 5500 User’s Guide 097-55501-01 Revision M – January 2009
Chapter 4 Testing and Configuring the TimeHub
Configuring CC Signals
Figure 4-18. The Configuration Output Tab
If a CC Output Connector card is installed, the CC Cable Compensation field
associated with the card is enabled in the lower left corner.
1. Select the cable length as required using the drop-down list.
2. Click Ports to select the ports that will have the compensation applied. A
window appears, as shown in Figure 4-19.
Figure 4-19. Enabling Ports for CC Cable Compensation
3. Click the box that correspond to the ports that will have compensation, then click
Close.
Each individual output port can be selected to have the delay feature enabled or
disabled. For example, it is possible to delay ports 29 and 30 of a given card group
while not delaying any of the other ports in that group. The CCDENB keyword is
used to enable/disable the CC delay capability of individual output ports. See the
TL1 Reference Guide for details.
To Next Page
Loading...
Need help?
General
