Symmetricom TimeHub 5500 User Manual

097-55501-01 Revision M – January 2009 TimeHub 5500 User’s Guide 277
Chapter 6 Specifications
Factory Default Values
Output Driver Card Default Settings
Table 6-3 lists the factory defaults for the TimeHub 5500 Output Driver card.
User Changes to Factory Defaults
Use Table 6-4 to record any changes you make to the factory default settings.
Table 6-3 DS1 and E1 Output Module Default Settings
Setting Factory Default Range
Enable | Disable Outputs Enabled Settable for each output port
Framing
 N (prior to firmware
version 4236B)
 Y (firmware version
4236B and higher)
Y (ESF) | N (D4)
Output Quality Level 9 1 to 9
Table 6-4 User Changes to Factory Default Settings
Setting Factory Default User Changes
Management Card Defaults
Security Off
Unit Name TimeHub
User List configurations Maximum of 25 users
EIA-232-C Port 9600 baud
Echo = Y
Ethernet IP Address IP Address 0.0.0.1
Gateway Address 0.0.0.1
Network Mask 255.255.248.0
Inactivity Time 100 sec
Clock Card Defaults
Bridged Mode N
CC Delay 0 ns
Freerun Action
 Continue (Master)
 Squelch (Remote)
Holdover and Freerun
Quality Level
 3 (ST2 Clock)
 5 (ST3E Clock)

Symmetricom TimeHub 5500 Specifications

General

Brand	Symmetricom
Model	TimeHub 5500
Category	Data Loggers
Language	English