198 TimeHub 5500 User’s Guide 097-55501-01 Revision M – January 2009
Chapter 4 Testing and Configuring the TimeHub
Enabling Security
Factory-set user security levels are described in Table 4-5. Use Edit User Security
to change a user’s access level.
Factory-set command security levels are described in Table 4-6. The TL1
Reference Guide includes the command security levels for each command, and
provides information on changing the access level of a command.
To enable security, set switch S1-1 on the Management card to On and a create a
user and password.
1. Remove the Management card from the shelf and examine switch S1 (see
Figure 4-2).
2. If the Management card switch S1-1 is set to Off (factory setting), skip to Step 5.
If the Management card switch S1-1 is set to On, continue with Step 3.
3. Set switch S1-1 to Off.
4. Install the Management card into its slot (see Installing the Management Card,
on page 139).
Table 4-5. User Level and Access
Security Level Description
User Users can edit their password and retrieve information, or access any
command at the User security level.
Administration Users are allowed to change configuration and issue User-level
commands.
Security Users are allowed to modify the security database or download new
firmware and issue commands at any level.
Table 4-6. Command Level and Access
Security Level Description
None Commands that can be executed without logging on. If the Security
Enabled switch (S1-1) on the Management card is off, all commands
behave as if their security level were None.
User Commands that only allow the user to retrieve information.
Administration Commands that allow the user to change configuration.
Security Commands that all the user to modify the security database or
download new firmware.
To Next Page
Loading...
Need help?
General
