Telit Wireless Solutions WE866E4-P - SSL Initialize

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 103 2018-02-16
PRELIMINAR
Y
9.3.1.9 SSL Initialize
This command is used to connect to SSL. Prior to issuing this command, user is required to
establish L2 and L3 connection.
Command Syntax AT+NSSLINIT=<SSL Client/Server>,<Protocol>
Parameter Description
Table 212, page 103, describes the SSL Initialize parameters.
Response
Table 213, page 103, describes the responses and remarks for SSL Initialize command.
Synchronous Response
Table 214, page 103, describes the synchronous responses and remarks for SSL Initialize
command.
Table 212 SSL Initialize Parameters
Parameters Mandatory/Optional Value Description
Client/Server Mandatory
Value range:1-2
Format: Integer
Default value: 2
It specifies the role of SSL,
1- acts as Client
0- acts as Server.
Protocol Mandatory
Value range:0-4
Format: Integer
Default value: 2
It specifies the version of the protocol
being used:.
0 - TLS 1.0,
1 - TLS 1.1,
2 - TLS 1.2,
3 - DTLS 1_0,
4 - DTLS 1_2.
Table 213 SSL Initialize Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 214 SSL Initialize Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.