Telit Wireless Solutions WE866E4-P - Socket Status Information

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 88 2018-02-16
PRELIMINAR
Y
Parameter Description
Table 168, page 88, describes the Socket Information parameters.
Response
Table 169, page 88, describes the responses and remarks for Socket Information command.
Synchronous Response
Table 170, page 88, describes the synchronous responses and remarks for Socket
Information command.
9.2.7 Socket Status Information
This command is used to get the status of information in the socket. Prior to issuing this
command, user is required to establish L2 and L3 connection.
Command Syntax AT+SS=<CID>,[<Reset counters>]
Parameter Description
Table 171, page 89, describes the Socket Status Information parameters.
Table 168 Socket Information Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+SC or AT+SA command.
Table 169 Socket Information Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 170 Socket Information Synchronous Response
Responses Remarks
+SI:IPv4/IPv6,TCP/UDP,L
ocalip (in case of
server)/serverip (in case of
client), Localport (in case of
server)/serverport (in case of
client)
If socket exists.
FAILURE If there is no socket.