Telit Wireless Solutions WE866E4-P - MQTT Receive Request

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 114 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 241, page 114, describes the synchronous responses and remarks for MQTT
Disconnect command.
9.4.6 MQTT Receive Request
This command is used to send receive request. Prior to issuing this command, user is
required to establish MQTT connection.
Command Syntax AT+NMQTTRR=<CID>
Parameter Description
Table 242, page 114, describes the MQTT Receive Request parameters.
Response
Table 243, page 115, describes the responses and remarks for MQTT Receive Request
command.
Table 240 MQTT Connect Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 241 MQTT Disconnect Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 242 MQTT Receive Request Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value:
N/A
It specifies the connection ID returned
during the MQTT connect command.