Telit Wireless Solutions WE866E4-P - Socket Receive Ready

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 91 2018-02-16
PRELIMINAR
Y
Response
Table 178, page 91, describes the responses and remarks for Socket Receive command.
Synchronous Response
Table 179, page 91, describes the synchronous responses and remarks for Socket Receive
command.
9.2.10 Socket Receive Ready
This command is used to receive data from any client device. Prior to issuing this
command, user is required to establish L2 and L3 connection.
Command Syntax AT+SRR=<CID>
Parameter Description
Table 180, page 92, describes the Socket Receive Ready parameters.
Table 177 Socket Receive Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+SC command for UPD or AT+SA for
TCP.
Length Mandatory
Value range:
0-1460
Format: Integer
Default value:
1460
It specifies the value of the number of
bytes received.
Table 178 Socket Receive Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 179 Socket Receive Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.