Telit Wireless Solutions WE866E4-P - Pin Allocation Details; WE866 E4-P Module Pins Out

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 13 2018-02-16
PRELIMINAR
Y
2 Overview
This chapter provides the guidelines for using AT command line interface to design,
configure and provision WE866E4-P module in a Wi-Fi network using serial commands.
• About the Document, page 13
• AT Commands, page 13
• Information Response and Result Codes, page 15
2.1 About the Document
This document describe all AT commands implemented on the Telit wireless modules listed
in the Applicability Table.
2.2 AT Commands
The Telit wireless module family can be controlled via the serial interface using the
standard AT commands.
2.2.1 Command Definition
This document uses the following syntactical definitions:
– Special text fonts represent particular commands, keywords, variables, or window
sessions
– Color text indicates cross-reference hyper links to supplemental information
– Command notation indicates commands, subcommands, or command elements
Table 2, page 11, describes the text conventions used in this manual for software
procedures that are explained using the AT command line interface.