Telit Wireless Solutions WE866E4-P - MQTT Disconnect

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 113 2018-02-16
PRELIMINAR
Y
Table 237, page 113, describes the responses and remarks for MQTT Subscribe command.
Synchronous Response
Table 238, page 113, describes the synchronous responses and remarks for MQTT
Subscribe command.
9.4.5 MQTT Disconnect
This command is used to disconnect MQTT connection. Prior to issuing this command,
user is required to establish MQTT connection.
Command Syntax AT+NMQTTDISCONNECT=<CID>
Parameter Description
Table 239, page 113, describes the MQTT Disconnect parameters.
Response
Table 240, page 114, describes the responses and remarks for MQTT Disconnect
command.
Table 237 MQTT Subscribe Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 238 MQTT Subscribe Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 239 MQTT Disconnect Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value:
N/A
It specifies the connection ID returned
during the MQTT connect command.