WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 21 2018-02-16
PRELIMINAR
Y
5 Host Interaction
This chapter describes how a communication interface is established between Host and
WE866E4-P module.
• Startup Handling, page 21
• Interface, page 21
5.1 Startup Handling
Content required
5.2 Interface
5.2.1 Configure UART
This command is used to configure UART and set UART parameters.
Command Syntax ATB
Parameter Description
Table 4, page 22, describes the Configure UART parameters.
NOTE:
To Next Page
Loading...