Telit Wireless Solutions WE866E4-P - Get AP Configuration

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 54 2018-02-16
PRELIMINAR
Y
7.2.2 Get AP Configuration
This command is used to get the configuration of the AP.
Command Syntax AT+WNAPC?
Parameter Description
Table 87, page 54, describes the Get AP Configuration parameters.
Response
Table 88, page 54, describes the responses and remarks for Get AP Configuration
command.
Synchronous Response
Table 89, page 55, describes the synchronous responses and remarks for Get AP
Configuration command.
Table 87 Get AP Configuration Parameters
Parameters Value Description
Hidden SSID
Value range: 0,1
Format: Integer
Default value: 0
It specifies the hidden SSID created for a
Network, where:
0- disables the hidden SSID and
1-enables the hidden SSID
Beacon
Interval
Value range:
100-1000
Format: Integer
Default value: 100
Unit: TUs
It specifies the interval between the beacon
frames coming from access point.
It is measured in TUs (Time Units) where,
One TU is 1024 microseconds.
DTIM
Period
Value range:
1-255
Format: Integer
Default value: 3
Unit: seconds
DTIM (Delivery Traffic Indication Map)
depends on the Beacon Interval.
It specifies that when DTIM enabled
beacon frame arrives, station wakes up
with a default period value 3. So for every
three beacons, connected sleeping stations
wakes up and receive the beacon frames.
Table 88 Get AP Configuration Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.