Telit Wireless Solutions WE866E4-P - Get SNTP Configuration

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 44 2018-02-16
PRELIMINAR
Y
6.7.2 Get SNTP Configuration
This command is used to get the status of the server configuration in SNTP module. Prior
to issuing this command, user is required to issue SNTP start command.
Command Syntax AT+NSNTPCFG?
Parameter Description
Table 61, page 44, describes the Get SNTP Configuration parameters.
Response
Table 62, page 44, describes the responses and remarks for Get SNTP Configuration
command.
Table 60 SNTP Configuration Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 61 Get SNTP Configuration Parameters
Parameters Mandatory/Optional Value Description
Name Mandatory
Value range:N/A
Format: String
Default value:
pool.ntp.org
Server
Address
Mandatory
Value range:N/A
Format: String
Default value:
pool.ntp.org
It specifies the server address to be
configured.
Status Optional
Value range: N/A
Format: String
Default value:
N/A
It specifies the status of the configuration
(KOD, NORESPONSE)
Table 62 Get SNTP Configuration Response
Responses Remarks
OK Success.