Telit Wireless Solutions WE866E4-P - Disassociation

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 51 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 80, page 51, describes the synchronous responses and remarks for Get MAC Address
command.
7.1.5 Disassociation
This command is used to disconnect from the current connected network. Prior to issuing
this command user is required to initialize the WLAN interface by using AT+WI command
and device has to be connected to a network.
Command Syntax AT+WD=<WHANDLE>
Parameter Description
Table 81, page 51, describes the Disassociation parameters.
Response
Table 82, page 51, describes the responses and remarks for Disassociation command.
ERROR If parameter is not valid.
Table 79 Get MAC Address Response
Responses Remarks
Table 80 Get MAC Address Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 81 Disassociation Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the Device ID of the WLAN
interface, where
0- specifies disables WLAN interface
1- specifies enable the WLAN interface.
Table 82 Disassociation Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.