Telit Wireless Solutions WE866E4-P - Get Network; Disconnect Network

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 63 2018-02-16
PRELIMINAR
Y
7.2.9 Get Network
This command is used to get the status of the created Network.
Command Syntax AT+WNCR?
Response
Table 106, page 63, describes the responses and remarks for Get Network command.
Synchronous Response
Table 107, page 63, describes the synchronous responses and remarks for Get Network
command.
7.2.10 Disconnect Network
This command is used to disconnect a Network. Prior to issuing this command, the user is
required to be connected to a network in Station or AP mode.
Command Syntax AT+WNDC=<WHANDLE>
Parameter Description
Table 108, page 63, describes the Disconnect Network parameters.
Table 106 Get Network Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 107 Get Network Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 108 Disconnect Network Parameters
Parameters Mandatory/Optional Value Description
WHANDLE Mandatory
Value range: 0,1
Format: Integer
Default value: 0
It specifies the return value from
AT+WNI=1 command.
The user is required to be in AP mode
while issuing this command.