Telit Wireless Solutions WE866E4-P - Send NHTTP Client Connection

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 119 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 253, page 119, describes the synchronous responses and remarks for Configure
NHTTP Client Connection command.
9.5.3 Send NHTTP Client Connection
This command is used to close the HTTP Client Connection. Prior to issuing this command
L2 and L3 connection has to be established and HTTP client connection has to be initiated
and configured.
Command Syntax AT+NHTTPCSEND=<CID>,<Method>,<File path>
Parameter Description
Table 254, page 119, describes the Send NHTTP Client Connection parameters.
Table 252 Configure NHTTP Client Connect Connection Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 253 Configure NHTTP Client Connection Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 254 Send NHTTP Client Connection Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-16
Format: Integer
Default value: 0
It specifies the return value after issuing
the command AT+WNHTTPCINIT.
Method Mandatory
Value range:0-10
Format: Integer
Default value: 0
It specifies the HTTP method used as part
of HTTP request.
File Path Mandatory
Value range:0-32
Format: Integer
Default value:
N/A
It specifies the URI path to be used while
sending HTTP request