Telit Wireless Solutions WE866E4-P - System Settings; Open File

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 29 2018-02-16
PRELIMINAR
Y
6.4 System Settings
6.4.1 Open File
This command is used to open a specified file with options in the file name.
Command Syntax AT+YFOP=<FIle Name>,<Options>
Parameter Description
Table 21, page 29, describes the Open File parameters.
Response
Table 22, page 29, describes the responses and remarks for Open File command.
Synchronous Response
Table 23, page 30, describes the synchronous responses and remarks for Open File
command.
Table 21 Open File Parameters
Parameters Mandatory/Optional Value Description
File Path Mandatory
Value range: 1-64
Format: String
Default value:
N/A
It specifies the file name along with the
path.
Example:/sys/abc.txt
Options Mandatory
Value range:
0x0-0x2, 0x41,
0x42, 0xC1, 0xC2,
0x241, 0x242,
0x441, 0x442,
0x4C1, 0x4C2
Format: Hexa
Default value:
N/A
It specifies any of the following three
options, namely:
Open for reading only.
Open for writing only.
Open for reading and writing.
Table 22 File Open Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.