Telit Wireless Solutions WE866E4-P - Socket Send

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 92 2018-02-16
PRELIMINAR
Y
Response
Table 181, page 92, describes the responses and remarks for Socket Receive Ready
command.
Synchronous Response
Table 182, page 92, describes the synchronous responses and remarks for Socket Receive
Ready command.
9.2.11 Socket Send
This command is used to send the data to a specified address. Prior to issuing this
command, user is required to establish L2 and L3 connection.
Command Syntax AT+SN=<CID>,[<Destination Address>,<Port Number>,<Data>]
Parameter Description
Table 183, page 93, describes the Socket Send parameters.
Table 180 Socket Receive Ready Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the value given by issuing
AT+SC command for UPD or AT+SA for
TCP.
Table 181 Socket Receive Ready Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 182 Socket Receive Ready Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.