Telit Wireless Solutions WE866E4-P - Close File; Delete File

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 30 2018-02-16
PRELIMINAR
Y
6.4.2 Close File
This command is used to close a specified file. Prior to issuing this command, user is
required to open a File.
Command Syntax AT+YFCL=<File Discriptor>
Parameter Description
Table 24, page 30, describes the Close File parameters.
Response
Table 25, page 30, describes the responses and remarks for Close File command.
6.4.3 Delete File
This command is used to remove or delete a specified file. Prior to issuing this command,
user is required to create File.
Command Syntax AT+YFRM=<File Name>
Parameter Description
Table 26, page 31, describes the Delete File parameters.
Table 23 Open File Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 24 Close File Parameters
Parameters Mandatory/Optional Value Description
File
Descriptor
Mandatory
Value range:
0X0-0XFFFFFFFF
Format: Hexa
Default value:
N/A
It specifies the value returned while
opening a file.
Table 25 Close File Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.