Telit Wireless Solutions WE866E4-P - PCB Pad Dimensions

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 38 2018-02-16
PRELIMINAR
Y
Response
Table 46, page 38, describes the responses and remarks for Data Mode command.
Synchronous Response
Table 47, page 38, describes the synchronous responses and remarks for Data Mode
command.
6.4.11 Echo Mode
This command is used to enable or disable Echo mode.
Command Syntax ATEn
Parameter Description
Table 48, page 38, describes the Echo Mode parameters.
Response
Table 49, page 39, describes the responses and remarks for Data Mode command.
Table 46 Data Mode Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 47 Data Mode Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 48 Echo Mode Parameters
Parameters Mandatory/Optional Value Description
n Mandatory
Value range: 0,1
Format: Integer
Default value: 1
It specifies the enable or disable of Echo
mode, where:
1- enables Echo mode
0- disable Echo mode.