Telit Wireless Solutions WE866E4-P - MQTT Publish

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 110 2018-02-16
PRELIMINAR
Y
Table 230, page 110, describes the Get MQTT Connect parameters.
Response
Table 231, page 110, describes the responses and remarks for Get MQTT Connect
command.
Synchronous Response
Table 232, page 110, describes the synchronous responses and remarks for Get MQTT
Connect command.
9.4.3 MQTT Publish
This command is used to Publish MQTT message. Prior to issuing this command, user is
required to establish MQTT connection.
Command Syntax AT+NMQTTPUBLISH=<CID>,<QOS>,<Retain Flag>,<Message ID>,<Topic
Name>,<Data>
Parameter Description
Table 233, page 111, describes the MQTT Publish parameters.
Table 230 Get MQTT Connect Parameters
Parameters Mandatory/Optional Value Description
Connection
Status
Mandatory
Value range: N/A
Format: String
Default value:
N/A
It specifies the status of MQTT connection
(CONNECTED or NOT CONNECTED).
Table 231 Get MQTT Connect Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 232 Get MQTT Connect Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.