Telit Wireless Solutions WE866E4-P - PCB Solder Pad Design

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 37 2018-02-16
PRELIMINAR
Y
Response
Table 43, page 37, describes the responses and remarks for Get Auto Mode command.
Synchronous Response
Table 44, page 37, describes the synchronous responses and remarks for Get Auto Mode
command.
6.4.10 Data Mode
This command is used to enable Data mode.
Command Syntax ATAn
Parameter Description
Table 45, page 37, describes the Data Mode parameters.
Table 42 Get Auto Mode Parameters
Parameters Value Description
Status
Value range: 0,1
Format: String
Default value: 1
It specifies the status of the Auto mode
operation (ENABLE or DISABLE).
Table 43 Get Auto Mode Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 44 Get Auto Mode Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 45 Data Mode Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range: 0-15
Format: Integer
Default value:
115200
It specifies the data mode that has to be
enabled for the CID.