Telit Wireless Solutions WE866E4-P - Read File

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 33 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 33, page 40, describes the synchronous responses and remarks for File List
command.
6.4.6 Read File
This command is used to read the specified number of bytes from the specified file with a
given offset. Prior to issuing this command, the file must be open.
Command Syntax AT+YFRD=<FIle Descriptor>,<Offset>,<Length>
Parameter Description
Table 34, page 34, describes the Read File parameters.
ERROR If parameter is not valid.
Table 32 File List Response
Responses Remarks
Table 33 File List Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.