Telit Wireless Solutions WE866E4-P - Get NMDNS Stop; Stop NMDNS Module

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 131 2018-02-16
PRELIMINAR
Y
10.1.2.9 Stop NMDNS Module
This command is used to start mDNS module. Before issuing this command is required to
issue L2 and L3 commands.
Command Syntax AT+NMDNSSTOP
Response
Table 286, page 131, describes the responses and remarks for Stop NMDNS Module
command.
Synchronous Response
Table 287, page 131, describes the synchronous responses and remarks for Stop NMDNS
Module command.
10.1.2.10 Get NMDNS Stop
This command is used to start mDNS module. Before issuing this command is required to
issue L2 and L3 commands.
Command Syntax AT+NMDNSSTART?
Parameter Description
Table 288, page 131, describes the Get NMDNS Stop parameters.
Table 286 Stop NMDNS Module Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 287 Stop NMDNS Module Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 288 Get NMDNS Stop Parameters
Parameters Mandatory/Optional Value Description
Status Mandatory
Value range:1-64
Format: String
Default value:
N/A
It specifies the NMDNS module has
STARTED or RUNNING.