Telit Wireless Solutions WE866E4-P - NDNS Service Discovery

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 78 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 146, page 78, describes the synchronous responses and remarks for NDNS Server
Host Addition command.
8.2.9 NDNS Service Discovery
This command is used to perform service discovery in DNS module. Prior to issuing this
command the user is required to issue WNCN command.
Command Syntax AT+NDNSSD=<Device ID>,<Instance Name>,[<IP Version>,<Time Out>]
Parameter Description
Table 147, page 78, describes the NDNS Service Discovery parameters.
ERROR If parameter is not valid.
Table 145 NDNS Server Host Addition Response
Responses Remarks
Table 146 NDNS Server Host Addition Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 147 DNS Service Discovery Parameters
Parameters Mandatory/Optional Value Description
Device ID Mandatory
Value range:0,1
Format: Integer
Default value: 0
It specifies the Device ID obtained during
WLAN NCM initiation.