Telit Wireless Solutions WE866E4-P - WNCM Interface Configuration

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 65 2018-02-16
PRELIMINAR
Y
Synchronous Response
Table 113, page 65, describes the synchronous responses and remarks for Initialization
command.
7.2.12 WNCM Interface Configuration
This command is used to provide information of different interfaces like device identifier,
state, mode, mac address, IP address.Prior to issuing this command, the user is required to
issue the initialize NCM command.
Command Syntax AT+WNIFCFG
Response
Table 114, page 65, describes the responses and remarks for Interface Configuration
command.
Table 112 Initialization Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 113 Initialization Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 114 Interface Configuration Response
Responses Remarks
+WNIFCFG:device_id,
state, mode, MAC address,
IP address
Success.
+WNIFCFG:FAILURE Failure.