Telit Wireless Solutions WE866E4-P - SSL Close

WE866E4-P AT Commands Reference Guide
80572ST10887A Rev. 0.0 99 2018-02-16
PRELIMINAR
Y
Response
Table 201, page 99, describes the responses and remarks for SSL Certificate Bind
command.
Synchronous Response
Table 202, page 99, describes the synchronous responses and remarks for SSL Certificate
Bind command.
9.3.1.6 SSL Close
This command is used to close the SSL connection. Prior to issuing this command, user is
required to establish L2 and L3 connection.
Command Syntax AT+NSSLCL=<CID>
Parameter Description
Table 203, page 100, describes the SSL Close parameters.
Table 200 SSL Certificate Bind Parameters
Parameters Mandatory/Optional Value Description
CID Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the connection ID after
AT+NSSLINIT command.
Local IP Address Optional
Value range:0-15
Format: Integer
Default value: 0
It specifies the local IP Address to bind.
Local port number Mandatory
Value range:0-15
Format: Integer
Default value: 0
It specifies the local port number to bind.
Table 201 SSL Certificate Bind Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.
Table 202 SSL Certificate Bind Synchronous Response
Responses Remarks
OK Success.
ERROR If parameter is not valid.